Not the cheapest filament, but didn’t require drying. Too lazy to dry it, and it takes 10 or more hours.
Just had to change the Z offset, by kind of a lot, it was too close. Not sure it’s exactly right now either, or maybe the bed temp is too high. Didn’t see any stringing the third time on the Z calibration print.
250C and 100C bed, some kind of garolite bed. I have the Blizzard White color of their PCTG. I forget the exact garolite it is.
Seemed to not stick enough @ 85C, the PETG temp I was using. It sticks, but can be removed before it’s cooled down. Is that sticky enough? That’s what she said.
But I only changed the temps, nothing else, from the PETG profile I was using. Printing a flow calibration now, then it’ll be good enough for me.
And the picture of the last Z calibration won’t be uploaded to Nextcloud for a while, it’s on MEGA though. It’s uploading all photos and videos from my phone, very slow if you don’t leave app open.
And might be the bed temp, cause it goes down fine. But after a while, might become transparent, maybe lower to 95C or 90C. They say the max is 100C, but may be too hot for my setup. Have to wait for print to finish to know for sure, but it was fine when I checked right after it printed.