It came with some build plate I had in the past. Just sticks on the printer bed. But after the last big print, the build plate wasn’t stuck down at all. Coming up more then usual.
If it does that with this print too, I need a new build plate.
Heats the bed up faster without that extra magnet thing too. Not sure it changed the bed leveling much, I ran Bed Visualizer. Looks about the same. I can go up higher now, but too lazy to change the setting. I don’t mind artificially limiting my height.
If only I could do that in real life.
Probably should have trammed bed again.
Oh and PETG supports are almost impossible to remove with bare hands. At least with a nozzle temperature of 240C.