One of the screws is missing a nut, on the hotend. It melted a long time ago.
No idea what kind of nut it uses, or how to put it on. I can’t even get the one off the other one. Maybe with pliers.
But printing first layer @ 0.3mm seems to fix it anyways.
Also, the silicone socks I got don’t fit that great, might still work though. That may have helped too, Bed Visualizer is different after putting silicone sock on it. But there might have been junk on nozzle too. Cleaning the nozzle all the time is annoying, so ordered a pack of silicone socks on Amazon. I should look for a replacement nut. That will make it more even on both sides most likely.
Same seller that sold me the copper heat sink, so no idea why the socks don’t fit great.
Might need a washer combination screw, I found a pack of screws, that might come with the right ones.
Kind of pricey though. Sold out on that site, bummer.
Think I need either M545 Screws with Washers or M525 Screws with Washers. So buy both, no need to measure or look at screw. But I think it’s the 2 one. No, the longer ones. Can I use a screw with a washer? Regular washer, not attached somehow. And it’s a washer not nut.
I don’t see why that wouldn’t work, if I replace both with the same way. Too bad this kit doesn’t have 25 too. Think it’s a lock washer, what’s the difference? And how do you put a lock washer on?
Ordered a pack of screws. Will need to probably tram bed, and get offset right again. Or maybe not tram bed, I’m lazy.