Same print has blobs and gaps

Not convinced the filament is wet, 36% in dry box. Probably about the same as after I dried it, the sensor in it, isn’t very accurate.

But that test Z calibration print, had blobs, and gaps. So making the Z farther away, isn’t working, still get blobs, and then get gaps.

Well, going to fix the wires after nozzle cools down, already removed the filament, had to flash firmware and enable something, so I could send the unload code to it. The change filament I tried, but it doesn’t fully eject filament, then just loads it. I had to run the unload command more then once. But maybe the blobs are from a slightly clogged nozzle, I cleaned it out with my new tool.