Put ferrules on the nozzle cables, I assume that’s for the heater. Forgot all about the bed, that’ll have to wait, as it took a long time to do. One wire is slightly shorter. Cause I don’t have a clue what I’m doing. Don’t use the little holes, use the 16awg or whatever slicer cutter thingy.
The screen wire isn’t right, it’s shorter then before now. Not that I need the screen much.
Printer fell on the way I should have had it to begin with.
The problem is plugging in the wires with the motherboard installed, real pain in the ass, you can’t see what you are doing. Was it worth it? Probably not. Not everybody’s wires smoke. And I forgot to do the bed wire, so didn’t even finish the job.
Still loading the filament.
Not a great job. Somebody said it takes a few minutes, more like a few hours.
Got to run AutoBim again. Then level, then offset, then level again.
If you aren’t against YouToot videos, I’d recommend watching a video on how to do it.
Yes some wire is probably sticking out of it. Too blind to cut it off. And lazy.
Who knows, maybe I made the problem that could happen, worse. Should have used hot glue.
Hopefully the one wire possibly being slightly shorter doesn’t matter. I only had instructions for the crimping part. Not the cutting part.
Hmm, wasn’t going down, the Z axis, turned off, unplugged the motor, plugged back in, now it works. But there’s more backlash, when going down. Probably messed that up again.
Must have fixed itself, probably because I rotated the thing on the motor to see if it could move up and down.
I don’t think I ever got the broken cable for the CRtouch out of the sleeve. So it’s just hanging out. That’s what she didn’t say.
And not as many, I’d reckon, making it a little farther away, might make it blob free now. Probably nozzle needed to be cleaned, and printer reset, and AutoBrim ran before leveling it.
So I possibly fixed the blob problem almost, all thanks to moving the printer and messing up the bed leveling, and redoing it. And flashing firmware so I could unload the filament all the way.
Do they make ferrules for penises? A permanent condom. You can fuck like a Queen, with a dick.
If this offset doesn’t work, I might just get it when it’s at printing temp, with a feeler gauge. As I’m sick of guessing. And apparently not heated, it isn’t right. That is the nozzle, not just the bed.
When calibrating Z offset, if you were ever too close, you may need to clean out the nozzle. I’d recommend NoClogger. Worth it, so you don’t have to keep buying cleaning filament.
I was going to go to bed after the last print, but I must get Z offset blob free, or mostly blob free.
That’s a good idea, make a shared hosting business, that charges a cleanup fee just in case they do BS. I have a reseller account already. So charge $100 per month for the base package. No refunds, sold as is.