Don’t keep making new bed meshes with Bed Visualizer @ different offsets. Doesn’t seem to work.
- Make a bed mesh @ offset 0
- Get offset after it’s done
- Print the Z calibration and use the Tune menu
- Save the Tune Z offset
- Print again and hope it works
I’ll know once I print the calibration again if that method works. Perhaps I should have looked up the correct method with auto leveling.
Damn, I made it too far, the end of the print got gaps. Made is a little closer. For the next print, I can tune that one too.
If you aren’t watching it, you risk having to tune it again.
Looks pretty good, and I haven’t been watching it. Had to take a big bloody dump. The offset is -2.00, so 0.10 farther away from bed. Don’t change the bed mesh, if that has no blobs or gaps, or very little blobs.
Still blobs. Not sure it can be made any better. At least with OrcaSlicer, since I don’t know what to change in it.
Apparently some people don’t tilt it. Might have to try doing that, since tilting just changes the offset.