Changed some of the speed settings, still won’t print a retraction test right. The Z offset is fine in Cura. So some setting in OrcaSlicer is different.
Now I’m not sure the first flow calibration was right. Where the numbers are supposed to be, looked awful, didn’t print all the numbers, or the -.
Blobs on brim too.
Well, that didn’t work. Changing Z offset now.
And offset was probably fine, set the Z offset to 0.1 in OrcaSlicer. If I want it 0, then I need to change offset on printer to -2.20. But then Cura won’t work, so I’ll pass.
Didn’t fix it, still too close, changed to -2.04. Tested with feeler gauge, that isn’t as tight. Feels pretty good, that’s what she said.
You know -2.10 is probably wrong, because -2.20 is wrong for 0.20mm feeler gauge. It lifts it up @ -2.00, the 0.20mm one. Hmm, -2.04 is about right, for 0.10mm, that’s -1.84 for 0.20mm. And it has printed at that offset somewhat good. No idea if Cura has a Z offset setting, if it does, I should see what it is. And change it to 0.10mm.
Well, it printed it, but not very good. Don’t think changing the offset will do much now. Going to print the second flow calibration. And go to bed while it’s printing. Too lazy to stay up until 1 AM.